| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clear Present bit before tearing down context entry
When tearing down a context entry, the current implementation zeros the
entire 128-bit entry using multiple 64-bit writes. This creates a window
where the hardware can fetch a "torn" entry — where some fields are
already zeroed while the 'Present' bit is still set — leading to
unpredictable behavior or spurious faults.
While x86 provides strong write ordering, the compiler may reorder writes
to the two 64-bit halves of the context entry. Even without compiler
reordering, the hardware fetch is not guaranteed to be atomic with
respect to multiple CPU writes.
Align with the "Guidance to Software for Invalidations" in the VT-d spec
(Section 6.5.3.3) by implementing the recommended ownership handshake:
1. Clear only the 'Present' (P) bit of the context entry first to
signal the transition of ownership from hardware to software.
2. Use dma_wmb() to ensure the cleared bit is visible to the IOMMU.
3. Perform the required cache and context-cache invalidation to ensure
hardware no longer has cached references to the entry.
4. Fully zero out the entry only after the invalidation is complete.
Also, add a dma_wmb() to context_set_present() to ensure the entry
is fully initialized before the 'Present' bit becomes visible. |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Fix race condition during PASID entry replacement
The Intel VT-d PASID table entry is 512 bits (64 bytes). When replacing
an active PASID entry (e.g., during domain replacement), the current
implementation calculates a new entry on the stack and copies it to the
table using a single structure assignment.
struct pasid_entry *pte, new_pte;
pte = intel_pasid_get_entry(dev, pasid);
pasid_pte_config_first_level(iommu, &new_pte, ...);
*pte = new_pte;
Because the hardware may fetch the 512-bit PASID entry in multiple
128-bit chunks, updating the entire entry while it is active (Present
bit set) risks a "torn" read. In this scenario, the IOMMU hardware
could observe an inconsistent state — partially new data and partially
old data — leading to unpredictable behavior or spurious faults.
Fix this by removing the unsafe "replace" helpers and following the
"clear-then-update" flow, which ensures the Present bit is cleared and
the required invalidation handshake is completed before the new
configuration is applied. |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: ab8500: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler has run.
This will lead to the IRQ handler calling `power_supply_changed()` with
a freed `power_supply` handle. Which usually crashes the system or
otherwise silently corrupts the memory...
Note that there is a similar situation which can also happen during
`probe()`; the possibility of an interrupt firing _before_ registering
the `power_supply` handle. This would then lead to the nasty situation
of using the `power_supply` handle *uninitialized* in
`power_supply_changed()`.
Commit 1c1f13a006ed ("power: supply: ab8500: Move to componentized
binding") introduced this issue during a refactorization. Fix this racy
use-after-free by making sure the IRQ is requested _after_ the
registration of the `power_supply` handle. |
| In the Linux kernel, the following vulnerability has been resolved:
md/md-llbitmap: fix percpu_ref not resurrected on suspend timeout
When llbitmap_suspend_timeout() times out waiting for percpu_ref to
become zero, it returns -ETIMEDOUT without resurrecting the percpu_ref.
The caller (md_llbitmap_daemon_fn) then continues to the next page
without calling llbitmap_resume(), leaving the percpu_ref in a killed
state permanently.
Fix this by resurrecting the percpu_ref before returning the error,
ensuring the page control structure remains usable for subsequent
operations. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/exynos: vidi: use priv->vidi_dev for ctx lookup in vidi_connection_ioctl()
vidi_connection_ioctl() retrieves the driver_data from drm_dev->dev to
obtain a struct vidi_context pointer. However, drm_dev->dev is the
exynos-drm master device, and the driver_data contained therein is not
the vidi component device, but a completely different device.
This can lead to various bugs, ranging from null pointer dereferences and
garbage value accesses to, in unlucky cases, out-of-bounds errors,
use-after-free errors, and more.
To resolve this issue, we need to store/delete the vidi device pointer in
exynos_drm_private->vidi_dev during bind/unbind, and then read this
exynos_drm_private->vidi_dev within ioctl() to obtain the correct
struct vidi_context pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
rcu: Fix rcu_read_unlock() deadloop due to softirq
Commit 5f5fa7ea89dc ("rcu: Don't use negative nesting depth in
__rcu_read_unlock()") removes the recursion-protection code from
__rcu_read_unlock(). Therefore, we could invoke the deadloop in
raise_softirq_irqoff() with ftrace enabled as follows:
WARNING: CPU: 0 PID: 0 at kernel/trace/trace.c:3021 __ftrace_trace_stack.constprop.0+0x172/0x180
Modules linked in: my_irq_work(O)
CPU: 0 UID: 0 PID: 0 Comm: swapper/0 Tainted: G O 6.18.0-rc7-dirty #23 PREEMPT(full)
Tainted: [O]=OOT_MODULE
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014
RIP: 0010:__ftrace_trace_stack.constprop.0+0x172/0x180
RSP: 0018:ffffc900000034a8 EFLAGS: 00010002
RAX: 0000000000000000 RBX: 0000000000000004 RCX: 0000000000000000
RDX: 0000000000000003 RSI: ffffffff826d7b87 RDI: ffffffff826e9329
RBP: 0000000000090009 R08: 0000000000000005 R09: ffffffff82afbc4c
R10: 0000000000000008 R11: 0000000000011d7a R12: 0000000000000000
R13: ffff888003874100 R14: 0000000000000003 R15: ffff8880038c1054
FS: 0000000000000000(0000) GS:ffff8880fa8ea000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 000055b31fa7f540 CR3: 00000000078f4005 CR4: 0000000000770ef0
PKRU: 55555554
Call Trace:
<IRQ>
trace_buffer_unlock_commit_regs+0x6d/0x220
trace_event_buffer_commit+0x5c/0x260
trace_event_raw_event_softirq+0x47/0x80
raise_softirq_irqoff+0x6e/0xa0
rcu_read_unlock_special+0xb1/0x160
unwind_next_frame+0x203/0x9b0
__unwind_start+0x15d/0x1c0
arch_stack_walk+0x62/0xf0
stack_trace_save+0x48/0x70
__ftrace_trace_stack.constprop.0+0x144/0x180
trace_buffer_unlock_commit_regs+0x6d/0x220
trace_event_buffer_commit+0x5c/0x260
trace_event_raw_event_softirq+0x47/0x80
raise_softirq_irqoff+0x6e/0xa0
rcu_read_unlock_special+0xb1/0x160
unwind_next_frame+0x203/0x9b0
__unwind_start+0x15d/0x1c0
arch_stack_walk+0x62/0xf0
stack_trace_save+0x48/0x70
__ftrace_trace_stack.constprop.0+0x144/0x180
trace_buffer_unlock_commit_regs+0x6d/0x220
trace_event_buffer_commit+0x5c/0x260
trace_event_raw_event_softirq+0x47/0x80
raise_softirq_irqoff+0x6e/0xa0
rcu_read_unlock_special+0xb1/0x160
unwind_next_frame+0x203/0x9b0
__unwind_start+0x15d/0x1c0
arch_stack_walk+0x62/0xf0
stack_trace_save+0x48/0x70
__ftrace_trace_stack.constprop.0+0x144/0x180
trace_buffer_unlock_commit_regs+0x6d/0x220
trace_event_buffer_commit+0x5c/0x260
trace_event_raw_event_softirq+0x47/0x80
raise_softirq_irqoff+0x6e/0xa0
rcu_read_unlock_special+0xb1/0x160
__is_insn_slot_addr+0x54/0x70
kernel_text_address+0x48/0xc0
__kernel_text_address+0xd/0x40
unwind_get_return_address+0x1e/0x40
arch_stack_walk+0x9c/0xf0
stack_trace_save+0x48/0x70
__ftrace_trace_stack.constprop.0+0x144/0x180
trace_buffer_unlock_commit_regs+0x6d/0x220
trace_event_buffer_commit+0x5c/0x260
trace_event_raw_event_softirq+0x47/0x80
__raise_softirq_irqoff+0x61/0x80
__flush_smp_call_function_queue+0x115/0x420
__sysvec_call_function_single+0x17/0xb0
sysvec_call_function_single+0x8c/0xc0
</IRQ>
Commit b41642c87716 ("rcu: Fix rcu_read_unlock() deadloop due to IRQ work")
fixed the infinite loop in rcu_read_unlock_special() for IRQ work by
setting a flag before calling irq_work_queue_on(). We fix this issue by
setting the same flag before calling raise_softirq_irqoff() and rename the
flag to defer_qs_pending for more common. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Fix a crash due to incorrect cleanup usage of kfree
Annotating a local pointer variable, which will be assigned with the
kmalloc-family functions, with the `__cleanup(kfree)` attribute will
make the address of the local variable, rather than the address returned
by kmalloc, passed to kfree directly and lead to a crash due to invalid
deallocation of stack address. According to other places in the repo,
the correct usage should be `__free(kfree)`. The code coincidentally
compiled because the parameter type `void *` of kfree is compatible with
the desired type `struct { ... } **`. |
| Subscriber SQL Injection in GamiPress <= 7.8.7 versions. |
| Unauthenticated Sensitive Data Exposure in Amelia <= 2.2 versions. |
| Unauthenticated Cross Site Scripting (XSS) in Favicon Rotator <= 1.2.11 versions. |
| Unauthenticated Cross Site Scripting (XSS) in AutomatorWP <= 5.6.7 versions. |
| Unauthenticated Broken Access Control in Salon booking system <= 10.30.25 versions. |
| Unauthenticated Broken Authentication in Email Marketing for WooCommerce by Omnisend <= 1.18.0 versions. |
| Subscriber Cross Site Scripting (XSS) in EventPrime <= 4.3.2.1 versions. |
| Unauthenticated PHP Object Injection in EventPrime <= 4.3.2.1 versions. |
| Subscriber Privilege Escalation in Amelia <= 2.3 versions. |
| Unauthenticated Cross Site Scripting (XSS) in Funnel Builder by FunnelKit <= 3.15.0.2 versions. |
| Unauthenticated Cross Site Scripting (XSS) in Drag and Drop Multiple File Upload – Contact Form 7 <= 1.3.9.7 versions. |
| Unauthenticated Privilege Escalation in Listdom <= 5.5.0 versions. |
| Unauthenticated Sensitive Data Exposure in Conekta Payment Gateway <= 6.0.0 versions. |
