| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Tobit Laboratories AG TeamDavid's Webbox 's sending email, fax, SMS, etc. functionality accepts a
@@INCLUDE command, which can be set to network locations using UNC paths
(e.g., “\\Server\Share”). The server processes these paths without
validation, resulting in outbound connection attempts to
attacker-controlled SMB servers. This enables authenticated attackers to
trigger the server to authenticate to arbitrary SMB endpoints,
potentially exposing NTLM authentication information (such as NTLM
hashes). If outbound connections to port 445 (SMB) are permitted,
attackers can use this to conduct SMB relay or credential theft attacks.
Exploitation of the “pathname” parameter is possible without
authentication. This issue affects TeamDavid through Rollout 524. |
| In the Linux kernel, the following vulnerability has been resolved:
time/jiffies: Register jiffies clocksource before usage
Teddy reported that a XEN HVM has a long boot delay, which was bisected to
the recent enhancements to the negative motion detection. It turned out
that the jiffies clocksource is used in early boot before it is registered,
which leaves the max_delta_raw field at zero. That causes the read out to
be clamped to the max delta of 0, which means time is not making progress.
Cure it by ensuring that it is initialized before its first usage in
timekeeping_init(). |
| In the Linux kernel, the following vulnerability has been resolved:
HID: wacom: stop hardware after post-start probe failures
wacom_parse_and_register() starts HID hardware before registering inputs
and initializing pad LEDs/remotes. Those later steps can fail, but their
error paths currently release Wacom resources without stopping the HID
hardware.
Route post-hid_hw_start() failures through hid_hw_stop() before
releasing driver resources.
This issue was identified during our ongoing static-analysis research while
reviewing kernel code. |
| In the Linux kernel, the following vulnerability has been resolved:
debugobjects: Plug race against a concurrent OOM disable
syzbot reported a puzzling splat:
WARNING: kernel/time/hrtimer.c:443 at stub_timer+0xa/0x20
stub_timer() is installed as timer callback function in
hrtimer_fixup_assert_init(), which is invoked when
debug_object_assert_init() can't find a shadow object. In that case debug
objects emits a warning about it before invoking the fixup.
Though the provided console log lacks this warning and instead has the
following a few seconds before the splat:
ODEBUG: Out of memory. ODEBUG disabled
So the object was looked up in debug_object_assert_init() and the lookup
failed due a concurrent out of memory situation which disabled debug
objects and freed the shadow objects:
debug_object_assert_init()
if (!debug_objects_enabled)
return; obj = alloc();
if (!obj) {
// Out of memory
debug_objects_enabled = false;
free_objects();
obj = lookup_or_alloc();
// The lookup failed because the other side
// removed the objects, so this returns
// an error code as the object in question
// is not statically initialized
if (!IS_ERR_OR_NULL(obj))
return;
if (!obj) {
debug_oom();
return;
}
print(...)
if (!debug_objects_enabled)
return;
fixup(...)
The debug object splat is skipped because debug_objects_enabled is false,
but the fixup callback is invoked unconditionally, which makes the timer
disfunctional.
This is only a problem in debug_object_assert_init() and
debug_object_activate() as both have to handle statically initialized
objects and therefore must handle the error pointer return case
gracefully. All other places only handle the found/not found case and the
NULL pointer return is a signal for OOM. Otherwise they get a valid shadow
object.
Plug the hole by checking whether debug objects are still enabled before
invoking the print and fixup function in those two places. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: core: fix uninitialized data in debugfs
If *ppos is non-zero then simple_write_to_buffer() will not initialize
the start of buf[]. Non zero values for *ppos aren't going to work
anyway. Test for them at the start of the function and return -EINVAL. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: function: rndis: add length check to response query
Add variable representations for BufLength and BufOffset in
rndis_query_response(), and perform a length check on them.
This is identical to how rndis_set_response() handles these parameters. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: wacom: use GFP_ATOMIC in wacom_wac_queue_flush()
wacom_wac_queue_flush() is called via the .raw_event callback
(wacom_raw_event → wacom_wac_pen_serial_enforce → wacom_wac_queue_flush).
For USB HID devices, this callback is invoked from hid_irq_in(), which
is a URB completion handler running in atomic context. Using GFP_KERNEL
in this path can sleep, leading to a "scheduling while atomic" bug.
Use GFP_ATOMIC instead. The existing code already handles allocation
failure by skipping the fifo entry and continuing. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/khugepaged: write all dirty file folios when collapsing
[There is no upstream commit, as this code was removed by upstream
commit 044925f9b565 ("mm: fs: remove filemap_nr_thps*() functions and their users")]
As-is, khugepaged and writable-file opening exclude each other. A file
cannot be open writeable and have THPs (because the filesystem is not aware
of them). khugepaged will never collapse file pages for files that are
opened writeable. On an open(O_RDWR/O_WRONLY), the page cache for that
particular file is dropped. This is fine because nothing could've been
dirtied.
However, there is an edge-case: collapse_file() might not be able to
coexist with concurrent writers, but it can coexist with dirty folios
(from previous writers). Therefore, the following can happen:
open(file, O_RDWR)
write(file)
close(file)
madvise(file_mapping, MADV_COLLAPSE, some non-dirty range)
open(file, O_RDWR)
nr_thps > 0
truncate_inode_pages()
/* THPs are cleared out, but so are the dirty folios */
When this edge-case happens, there is data loss, as the dirty folios are
fully discarded.
Fix it by fully writing back the page cache (and waiting) when collapsing
file THPs. Doing so provides the guarantee that no dirty folio will be
observed while there are active THPs. To fully ensure this is safe, the
invalidate_lock needs to be held while doing the writeout, so that
do_dentry_open()'s page cache truncation excludes this write-and-wait.
As a side effect, move the nr_thps counter bumping outside the i_pages
lock. This is correct since the counter itself is an atomic_t and the
producer <-> consumer correctness is provided by a full memory barrier:
smp_mb() in collapse_file()/memory barrier implied by full ordering in
get_write_access() -> atomic_inc_unless_negative(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_uart: clear HCI_UART_SENDING when write_work is canceled
HCI_UART_SENDING bit in tx_state means write_work is pending and blocks
queueing it again. Currently this bit is not cleared when canceling the
work in hci_uart_close(), which blocks future writes when device is
reopened later if write_work was pending.
Fix by clearing HCI_UART_SENDING when canceling the work.
Also make clearing of tx_skb safe by using disable_work_sync +
enable_work instead of just cancel_work_sync. hci_uart_flush() purges
the proto tx queue so we can cancel the pending write_work there,
instead of doing it just in hci_uart_close(). Re-enable and possibly
requeue the work after queue flush. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: vme_user: fix location monitor leak in tsi148 bridge
tsi148_probe() allocates a location monitor resource and links it into
tsi148_bridge->lm_resources. The probe error path frees this list, but
tsi148_remove() only frees the dma, slave and master resource lists, so
the location monitor resource is leaked on device unbind or module
unload.
Free the lm_resources list in tsi148_remove() as well, before
tsi148_bridge is freed. |
| A stored cross-site scripting (XSS) vulnerability in lobehub/lobe-chat through v2.2.13 allows a low-privileged authenticated user to inject arbitrary JavaScript into the application by uploading a crafted SVG file as a user avatar. |
| A missing authentication vulnerability in dulldusk/phpfm through 1.8.0 allows an unauthenticated remote attacker to access the full file manager functionality including reading, writing, deleting, and uploading files anywhere on the server filesystem. |
| An unrestricted file upload vulnerability in dulldusk/phpfm through 1.8.0 allows an unauthenticated remote attacker to execute arbitrary PHP code on the server. The application ships with an empty upload extension filter ( = array) and no authentication enabled by default (auth_pass is empty string), allowing an unauthenticated attacker to upload a PHP webshell and execute it by browsing to the uploaded path. |
| A server-side request forgery (SSRF) vulnerability in gabehf/Koito through v0.3.2 allows an authenticated user to make the server perform HTTP requests to arbitrary internal or external hosts by supplying a crafted image_url value in the PATCH /apis/web/v1/album/{id}/image endpoint. |
| An OS command injection vulnerability in alseambusher/crontab-ui through 0.4.2 allows an unauthenticated remote attacker to inject arbitrary cron job entries by sending a crafted GET request to /crontab with URL-encoded newlines in the env_vars parameter. |
| An OS command injection vulnerability in alseambusher/crontab-ui through 0.4.2 allows an unauthenticated remote attacker to execute arbitrary system commands by importing a crafted crontab database file. The POST /import endpoint accepts arbitrary .db files and overwrites the application database without validation. |
| A cache poisoning vulnerability in CoreBunch/Instatic through 0.0.14 allows an unauthenticated remote attacker to poison the shared process-wide render cache by manipulating the u query parameter of the GET /_instatic/hole/<nodeId> server island endpoint. |
| A missing authentication vulnerability in frangoteam/FUXA through 1.3.3 allows an unauthenticated remote attacker to query all historical sensor data via the DAQ_QUERY Socket.IO event. When secureEnabled=true, all other sensitive Socket.IO events (DEVICE_BROWSE, HOST_INTERFACES, DEVICE_TAGS_REQUEST, etc.) call isSocketAdminAuthorized to verify the connection token, but the DAQ_QUERY handler in server/runtime/index.js lacks this check entirely. |
| An authorization bypass vulnerability in Grafana through 13.2.0 allows an Editor-role user to delete protected contact points (receivers) without the required alert.notifications.receivers.protected:write permission. |
| A time-of-check/time-of-use (TOCTOU) race condition in fastschema through v0.15.1 allows an unauthenticated remote attacker to bypass the OTP attempt limit on the account recovery flow, enabling brute-force attacks on 6-digit OTP codes. |
